E3D or V6 Clone - Direct Feed to Bowden Adapter, mount, and fang for STOCK CR10, Ender 2, 3, 4.

cults3d

Thank you to @FinneganFalco for the design that sparked this creation. I recently made an order with a surprise twist, acquiring a Direct Feed V6 hotend clone instead of the Bowden version I had intended. As is often the case when faced with unexpected challenges, my response was "bring it on!" Utilizing the same innovative ideas as my extruder plate design, this adapter allows users to seamlessly integrate @FinneganFalco's fang and 40mm fan duct into a direct feed V6 hotend clone or even the original E3D hotend. To secure the ptfe tube in place, simply slide it up against the hotend and tighten the incorporated pressure fitting and nut. This setup enables users to take advantage of the more affordable Direct Feed hotend without compromising on performance due to a lack of Bowden fittings. Enjoy using this adapter and showcase your impressive creations! If you've found my Things designs helpful, consider showing your appreciation with a cup of coffee courtesy of the PayPal button below. Buy me a cup of coffee Buy me a cup of coffee $3.00 USD Treat me to a massive cup of coffee $5.00 USD Induce a caffeine coma in me $10.00 USD