E3D Hermera (Hermes) + Super Volcano Holder for MK3S

thingiverse

This is the first version!!! It's still a work in progress! Here are my current Holders for a Hermera and Super Volcano. The target was to make minor changes to the Firmware. So, I've kept the pinda-sensor in the same position, and moved the hotend 10mm closer to the front end of the magnetic bed. It's still on the bed, just close to the edge. For that reason, the extruder is rotated by 20 degrees. In the FW only a few things need to be adapted: the PID Values for the Hotend and the steps per mm have to be adjusted. The PID Values can be done with the PID-Automatic in the FW. For the Steps/mm I used Pronterface (just like in this guide: https://e3d-online.dozuki.com/Guide/Prusa+i3+MK3+Firmware+Modifications/141?lang=en). I also used 780 steps/mm. The cabling is currently a bit fuzzy. I'll rework this part to optimize it. I use it with a 1.4mm Nozzle... it's fast but rough... Attention! The 80W of the Hotend are close to the limit of the einsy board!! Maybe it would be useful to use the mosfet-kit from e3d. https://e3d-online.com/e3d-hemera-175-kit Hotend: 1.75mm and 24V https://e3d-online.com/the-e3d-supervolcano