E3D Hemera mount for LulzBot Taz 6

thingiverse

This is a one-piece mount for using the E3D Hemera/Hermes on the LulzBot Taz 6. Its dimensions are based on the official E3D mount. You don't need the separate Taz 6 Universal Mount if you're using this mount. I also modified the blower fan mount so it could attach using socket-cap screws. # Printing You will need to print the mount with ABS, PETG, or another high-temp material. Don't use PLA! For best printing, use the included support and perimeter modifier files. If you're using PrusaSlicer: 1. Select 0.25mm layer height, 3 perimeters, and 30% infill for your general print settings. 2. Load the "Taz Hemera mount" part. 3. Right-click the print settings, select Add Part > Load, select "Taz Hemera mount - support" part. 4. Right click print settings again, select Add Modifier > Load, select "Taz Hemera mount - perim modifier" part. Right click the modifier's settings, select Add Settings > Layers and Perimeters, select Perimeters. Change this to 4. If your slicer does not support modifiers, then increase the overall perimeters to 4 and infill to 50% or more. The included support should work in all slicers. It is designed with a 0.25mm gap between the support and part. # Post-Print Cleanup Use a 3.5mm drill bit (or similar) to clean the holes in the mount. # Required Parts - M3x8 or M3x10 socket cap screws (qty 4) to attach the Hemera to the mount. - M3x8 socket cap screws (qty 4) to attach the fan mount to the Hemera. - M3x20 socket-cap screws for attaching the blower to the fan mount. Ideally use M3 heat-set inserts on the fan mount, however you may be able to get away without them. - Cable harness (see E3D documentation). # Assembly Follow the E3D Guide for the Taz 6. You can skip the steps where they attach the Hermes and Universal Mount to each other.