E3D Heater Block Micro Z-Probe

pinshape

I crafted this bracket to fit snugly onto an E3D-V6 heater block, securely holding a tiny microswitch as a Z-Probe for calibration. The switch itself can be sourced from http://www.goldmine-elec-products.com/prodinfo.asp?number=G16909. A disconnectable harness should be wired up, allowing the bracket to be easily snapped on and off when running a calibration cycle is necessary. It's worth noting that the STL file included contains printed support built right in, with the model consisting of 3 separate pieces. However, I must emphasize that this bracket should not be used while the hot-end is still warm. When it comes to print settings, rafts and supports are inconsequential.