E3D Chimera - Parts collection

thingiverse

I was determined to get my setup just right, and after some trial and error, I finally assembled a package that truly satisfies me. A few components stood out as particularly worthy of inclusion, so I've bundled them together into one cohesive unit. Some modifications were necessary to make these parts work seamlessly with my specific setup. One notable change is the extension of the carriage to accommodate 45mm LM8LUU bearings - this has resulted in exceptional stability and minimal play on the rods. The fan duct has also been lengthened by 2.5mm to provide ample clearance for the heat blocks, but I would advise against using anything other than PETG or ABS for this component. The BLTOUCH mount remains unchanged, although I did need to employ a couple of washers to lower the touch point slightly and achieve optimal performance.