E3D bowden setup for Anet A8

myminifactory

Setting Up Your E3D Bowden Extruder on an Anet A8 3D Printer To install your E3D Bowden extruder on an Anet A8, start by removing the original hotend and set it aside for later use. Next, take the new E3D Bowden assembly and carefully thread the bowden tube through the idler bracket, ensuring a smooth and secure fit. Now, attach the E3D Bowden motor to the printer's frame using the provided screws, making sure not to overtighten them as this can cause damage to the motor. Next, connect the motor to your 3D printer's control board via the ribbon cable, following the manufacturer's instructions for correct wiring. Mount the bowden tube to the idler bracket and secure it with a set screw, then attach the E3D Bowden hotend to the end of the tube, ensuring a snug fit. Finally, reconnect the hotend to your 3D printer's control board, following the manufacturer's instructions for correct wiring. That's it! Your Anet A8 is now equipped with an E3D Bowden extruder, ready for use in printing high-quality objects.