E-Revo 1/16 Upright

prusaprinters

<p>This is printed replacement for the Mini E-Revo 1/16 front and rear uprights / steering knuckles.&nbsp;</p><p>It uses threaded Nuts to set the backlash of the spherical upper and lower wishbone joints. Take care that you dont overtighten the nuts to prevent excessive binding and steering forces.&nbsp;<br>Loctite for the thread is a good option to prevent them from loosening. You can also add a spot of grease to the spherical joints to reduce friction.</p><p>&nbsp;</p><p>Parts are currently in test phase and have been printed with Prusament PC-CF on a 0.4mm nozzle and a layer height of 0.1mm.<br>10 Top/Bottom Layers<br>4 Perimeters<br>40% Infill&nbsp;</p><p>no supports needed<br><br>Make sure you have your filament properly tuned as the parts require good dimensional accuracy for a proper fit of the wheel bearings.</p>