E-liquid Bottle cup JAPAN 6ml - Bottom Feeder

thingiverse

Hi there, users of e-cigarette boxmod bottom feeder. Many are familiar with the little square bottle used for squonk boxmods found here: http://www.japanesekitchen.co.uk/user/products/large/empty-rectangular-bottle-shape-sachets-7ml-x-100pcs-304-p.jpg. Using this original cup requires drilling a hole to insert a silicone tube, but often creating a perfect hole is difficult. This results in leaks of e-liquid during the squonk action. That's where these products come in, available in three different types: A hole with a diameter of 4.5mm for silicone tubes. Another option is a hole of 3.8mm for silicone tube inserts. There's also a hole of 3.5mm for the same purpose. The newest addition is a hole with a diameter of 3.4mm for users who need it. A small tube fits inside to secure a silicone tube on top, as well as one within the bottle itself. This design is sure to delight. Don't forget to publish your own "Made" version of this cup! Special thanks go to @mc0676 for their exceptional photos. **Updates:** Two new versions have been added - one with holes of 3.4mm and another with a hole of 4.5mm diameter. **Printing Settings:** Rafts are recommended not to be used when printing. To get the best results, supports should be enabled instead. 100% infill settings help solidify this item firmly in place. Special instructions must be followed carefully: 1. **Only use supports with the tube-type version of the cup.** 2. Keep your layer height set to 0.10mm to maintain precise detail on curved areas of the cup. 3. Nozzle settings: recommended minimum at 0.30mm for proper output quality. 4. Try to minimize extrusion width to its smallest size possible, depending on the characteristics of your nozzle. 5. Choose a reasonable print speed not exceeding 40mm/s for better ventilation to prevent over-heating caused by the hot end