E-Cigarette-, Liquid- and Battery-Display with integrated USB-Charger (New with seamless top)

thingiverse

Update 1: Extended battery slots for easy removal of 18650 batteries. Update 2: Enhanced diameter for the 42mm bottle holders. Update 3: Added files for a print with a seamless top, requiring a stop before the final millimeter to assemble and include the charger. The easiest method is to insert a filament change before layer 240 (on a 0.1 resolution) or layer 120 (on a 0.2 resolution). This holder was designed to hold up to four 22mm e-cigarette tubes or vaporizers, up to two liquid bottles with a diameter of up to 23mm (e.g., Unicorn Bottle 30ml), up to two liquid bottles with a diameter of up to 42mm (e.g., Chubby Gorilla 120ml) and up to three 18650 batteries. The middle battery slot contains a charger, utilizing a disassembled Efest SLIM K1 Charger for electronics. A sharp nipper or knife is needed to break the lower part from the upper part at the weld. Assembly tip: After printing both parts, remove the moving plus connector from the disassembled charger by releasing it from the spring. Then move the upper part through the slot of the charger part and connect it to the spring again. The charger must be placed in the holder with the front part first and firmly pressed into place until its surface is even with the surface of the holder part.