E-90X Frame Build

thingiverse

Added mounting hardware support for motors.\nMy custom E-90X frame Build features improved motor installation.\nTo secure the flight controller, I employed the same trick used for motor mounting. The main frame plate was machined to accommodate M3 bolts. A specially designed bottom component prevents bolt bending by supporting the bolt heads. This feature also serves as a rig for precision filing of the carbon fiber. \nA fixed and adjustable camera mount is included, offering an angle range from approximately -5 degrees to 60-65 degrees. Pilots who dare to fly with maximum tilt should inspect their antenna beforehand; if bent, propellers may collide with it. A M3x5mm knurled insert brass nut was used, cut in half and filed down to 2mm for optimal fit. The mount itself is 2mm thick, printed with 100% infill, weighing approximately 6 grams. \nMotor wires were shortened by around 25-30mm and integrated into the arm for a neater setup.\nParts list:\nFrame https://goo.gl/meqhXc\nFlight Controller https://goo.gl/oykGxQ\nMotors, ESCs: https://goo.gl/fYosOs\nRadiolink R6DSM Receiver https://goo.gl/ZOJyy8\nAIO Camera\nNTSC https://goo.gl/tFuBf3\nPAL https://goo.gl/MTRDrS\nBattery https://goo.gl/NCXvNK\nJST connector https://goo.gl/s0y4Uf\n18-20 AWG Silicone Wire https://goo.gl/WhJ1Ai\nTransparent Heat Shrink Tube https://goo.gl/oXltiL\nBrass Knurled Insert Nut M3x4x6 https://goo.gl/TUqFCA\nM3 Nylon Screw Nut Assortment Kit https://goo.gl/qp8pXI\nWalkera Ladybird Propellers https://goo.gl/FlQx5y\n1.4mm drill bits https://goo.gl/YpzJ8m\n5V Electromagnetic Active Buzzer https://goo.gl/nq99xP\nIf you appreciate my work, and want to see more designs, consider donating any amount for a filament.