Dyson V11/V10/V8/V7 Accessory Mount/Holder - Modded

cults3d

This is a reinforced version of the great Accessory holder by albrnick. I tried 2 times to print and use the original version, but accessories cause a breaking on the support between the two holders after a couple of weeks. So I edited the original version adding a bigger support. I also put a reinforcement where the holder goes inside the original dyson base. This causes this holder to be VERY strong and could be a bit difficult to remove it from the base after put inside. Attached there is only the "left" version, you can mirror it for the right one. I tested it with Dyson V11, it should be compatible also with V10, V8 and V7 like the original one. I printed with PLA, so I used an infill of 50% for have the support as stronger as I can.