Dyson V10/V11/V12 Extended storage

thingiverse

This is a reinforced version of the great Accessory holder by Leen 15. I tried 3 times to print and use the original version, but accessories cause a breaking on the support between the two holders after a couple of hours. So I edited the original version to more hight and more distance. Leen 15 put a reinforcement where the holder goes inside the original dyson base. This causes this holder to be VERY strong and could be a bit difficult to remove it from the base after put inside. So I edited the Leen 15 version to mproved the elasticity of the button, the base is easy to exit . Also tested it with Dyson V12 and V11,V10, it should be compatible also with V8 and V7 like the original one. I printed with PLA, so I used an infill of 50% for have the support as stronger as I can.