DYSON SONIC & Nozzle - Wall Mount

thingiverse

Fixation mural for Dyson Sonic Hair Dryer and its clips. Tip: The fixation of the Sonic is very tight. It is NECESSARY to perform a glass paper smoothing and obtain a smooth surface inside. The goal is to be as close to diameter, after treatment, as possible, have a perfectly smooth surface and therefore not scratch the hair dryer when inserting it. The clip wall mount has a groove to place a sheet of iron or steel cut into blades, so that the clips hold due to their magnets. Considering the thin thickness of the groove, attention is required for the entire assembly is fragile before reinforcement. I fixed and reinforced the entire assembly with hot glue. An additional exterior paint layer will also be necessary because the inserts are visible through transparency. Tip: I have also placed neodymium magnets in the grooves (circular parts) at the clip level to improve the magnetic hold, which was too light to my taste. Current project: preparation of a support for storing the Sonic's power cord.