Dyson DC14 Crevice tool mount clamp

thingiverse

The Dyson DC14 upright vacuum cleaner mounts the crevice tool on the side using a removeable C-clamp mount. After some time the ABS plastic breaks down or is affected by weather etc and removing the crevice tool can rip out or damage the mount. Version1 (printed in photos): This is a very close reproduction of the original after my one had broke. Some slight changes had been made; 1. The holes are 1.1mm larger to aide in removing support material. 2. The fillets/chamfers of the edges of the clamp and clips are as close as fusion 360, my skill and ability to measure would allow for. Version 2: Same as above, except the holes are much larger to further aide in removing support material. Not tested, but should work fine. Be careful not to break the clips off! Printed in PLA and worked fine. PETG would probably be fine too.