DYNAMIC DONG (Circumcised) M-Lok AFG

prusaprinters

<p>A foregrip that mimics the PM md. 63's unique forward-pointing front handgrip, known to many as the "Dong" grip, except people seem to like cutting these partially off... you could say *just the tip*.</p><p>Instead of cutting off the foresk- I mean the end of the foregrip off, this has been designed to already have a short, slanted bottom. And since this is much shorter than the original DYNAMIC DONG, I can legally call this an angled foregrip without the ATF being a bunch of basic bitches about it.</p><p>IT"S ANGLED FORWARD, FED BOIS!</p><p>This design is created to mount to M-Lok, essentially allowing attachment to any compatible forend on AKs; and any other weapons with M-Lok slotted forends.<br><br><br><strong>Print instructions</strong><br><br>Print Settings:</p><p>Extruder: 218C&nbsp;<br>Bed: 55C&nbsp;<br>First Layer Print Height: .18mm&nbsp;<br>Standard Layer Height: .14mm<br>Wall Thickness: .40&nbsp;<br>Wall Perimeters: 4 - 5<br>Infill: 28%<br>Infill Pattern: Gyroid<br>Material Flow: 100%<br>Support Material Percentage: 30%</p><p>Print the cut dong upside down.</p><p>&nbsp;</p><p>Hardware Required:</p><p>2x M5x10 Hex Socketed Machine Screw/Bolt</p><p>2x M-Lok T-Nuts (Be sure both bolt &amp; nut are the same thread pitch.)</p>