Dutch Row House

prusaprinters

<p>I modeled one of the Dutch row houses featured on the Stroopwafels box. The model is the same size as the picture on the box and roughly 1∶160 scale to a real building. To create the model follow the steps below:&nbsp;</p><ol><li>Print the windows. If they are not printing well try scaling up the size of the model.</li><li>Print the top and make sure to enable supports for this piece.&nbsp;</li><li>Print the front. To get the best surface finish make sure there are one or two layers of infill.</li><li>Print the back.&nbsp;</li><li>Superglue the windows (except for the top one) onto the front of the building.&nbsp;</li><li>Superglue the front to the back of the building.&nbsp;</li><li>Superglue the top onto the back/front.&nbsp;</li><li>Superglue the top set of windows onto the top/front.&nbsp;</li></ol><p>This model was printed on an Anycubic Mega Zero 2.0 with a 0.4 mm nozzle in HATCHBOX PLA filament. &nbsp;</p><p>Note: the windows can be difficult to print, make sure the print bed is level and has good adhesion.&nbsp;</p>