Dustpan broomstick wiper

pinshape

Mount this to your dustpan so that after sweeping, you can run your broom's bristles over the "teeth" to wipe off remaining stuck-on debris. I recommend printing in ABS with 100% infill for strength and flexibility. I had to bend mine a little for it to fit. It might have otherwise snapped with low infill or using PLA. I used .3 layer height, with a raft. The length is about 7 1/2 inches by 1 1/2 inch in depth. Scale as necessary depending on your dustpan's size. Three holes were added for screw mounts, but you might have to drill them slightly larger. Don't make them too large or it will crack. I used screws with a washer and bolt for added security instead of just a screw by itself.