Dusk Ball, with magnetic clasp (5th Gen)

thingiverse

This version of dusk ball with magnetic clasp draws inspiration from the sprite in the 5th gen DS games. To access similar designs for the 6th gen, visit http://www.thingiverse.com/thing:1081574\nGet started by printing out all the parts. Print two copies of Dusk_BlackShell_5thGen.stl - one for the lid and one for the bottom shell.\nAssembling the parts proves to be a tight fit due to their snap-together design, thus no glue is required most times.\nNext, glue the button and ring to the bottom shell with the hinge already in place. Simultaneously attach the ring down by gluing it before snapping the hinge into the lid.\nA crucial addition includes 2 magnets measuring (1/4" X 1/16"). Simply secure them in their designated spaces with adhesive.\nTip: Consider printing your bottom piece at a higher infill percentage, approximately 40-50%, and print all other components at an infill rate of 5-10%. This approach will result in the part being heavy on its base and less likely to roll away.\nPrint Settings:\n Raft Requirements\n Absolutely no need to bother with rafts here.\n No specific requirements exist for supports.\n When it comes to resolution, go with 0.2mm for the most detailed output.\n Choose an infill rate ranging from 5-50% depending on the part.\n Final Notes:\nThe bottom parts were printed using 40-50% infill for a heavy base and 2 shell prints per component except the top components, which were done at lower infill rates of 5-10%. No rafts or supports were necessary apart from the Dusk_BlackShell_6thGen.stl part that demanded them. To prevent overhang issues, rotate the z-axis to 45 degrees and print diagonal supports, allowing for easy removal later on.