DuraflyTundra - Tail Wheel Rudder Bracket

thingiverse

This is an upgraded attachment point for the Durafly Tundra's rudder, replacing the stock setup that relies on screws into plastic. The new design employs captured M3 nuts, which is the recommended method for securing this type of component. To ensure a proper fit, you'll need to install a M3x15 screw for the rudder hinge and two M3x10 screws for the tail wheel attachment. Before gluing the part in place, test out the lengths to confirm they're correct. You might also need to trim some foam from underneath the original component to accommodate the nuts. This revised attachment point is compatible with both the water rudder and tail wheel, eliminating the need for tape or heat shrink on the wire components.