Durafly Tundra V2 Landing Gear Retainer Brackets

thingiverse

Made these to replace broken brackets on my Tundra V2 (pretty sure its a V2). Original brackets are curved and these straight but they bend into place when you tighten the screws. I had to use screws a few mm longer than the stock screws to get enough thread (these are a bit thicker than the stock ones). I also got fancy and used PLA-HT+ material, printed enlarged 2%, then annealed them for added strength. At 2% they shrunk down to size just right. I only did this because I had some HT+ material laying around and figured what the hell. I'd probably at least use some sort of PLA+ for strength, or just use cheap stuff and make the brackets thicker, OR just print a handful of them and replace when they break, OR maybe they are fine with any material??? Included the source file because, it should be a rule that you include your source files so everyone does not have to ask.