Durable, water resistant, Drone (D.W.R.D)

thingiverse

The "indestructible" quad is easy to print and build, thanks to its simple design printed in PET with no support required. The camera angle adjusts smoothly in three modes: 0, 15, and 30 degrees. To switch between positions, simply push the levers together and snap them into place. To assemble the quad, you'll need a few additional components beyond electronics: * Aluminum tubes (12mm) or equivalent for motor arms * M3 screws and nuts * Zipties * A rubber band for securing the battery hatch (you can 3D print one if needed) The quad's electronics are straightforward: * KK2.1 board provides ample space for any additional components you might want to add. * E-max 20A ESC offers plenty of room for customization, just like the KK board. * Tyringy 1800mAh 30C Lipo battery fills the compartment to its maximum capacity. * Immerison's 600mw transmitter and Runcam Owl 700TVL camera make up a well-rounded setup.