Durable and Compact CV Joint for 1/8-inch square rod and 1/8-inch balls

thingiverse

This is a result of me trying to make a cv joint for a 4-wheel drive RC car. It works fine as I can tell with not much slop. Also, it hasn't melted on me yet with a drill running it. Additionally, the width of the outer part is .6 inches, and the length is around .675 inches. The width of the tube part slides into a bearing made for 1/4-inch square rods (so a diameter of around .31). Also attached is the fusion file of the design if anyone wants to remix it. They are not in their optimal printing orientation to start, and I personally print them on a thin raft as the parts are not the best suited for bed adhesion. It works no problem at 30 percent infill with a strong infill pattern. I used supports, but i think they aren't necessary if you have the right printer. More updates soon.