Duplicator i3 Plus X gantry rod supports

thingiverse

I have the PowerSpec version of the Duplicator i3 Plus. To print at 10% scale in SketchUp, you'll need to remove the top to access the X gantry and install new supports. At this point, it's a good idea to get rid of the belt spring and tighten the X belt very tightly. I used the original screws for this setup, as I have longer ones available that work just fine, but be cautious not to over-tighten them. The resulting assembly is massively more solid and stable than before. Just remember to avoid over-tightening or using bolts that are too long, as they may interfere with the lead screw.