Duplicator 7 - Better IncrediVat D7

thingiverse

Wanhao Duplicator 7 VAT Standard and XL. The Standard design shamelessly copied the official VAT, but with some improvements in store: slopped edges, pouring slopes, and increased capacity. - 330ml - Standard. - 350ml - Standard Enhanced. - 400ml - XL. - 420ml - XL Enhanced. Keep in mind that the XL version is a full 1cm taller than its standard counterpart. It will fit in v1.4, but I'm not entirely sure about other models. Use at your own risk. You'll need the following hardware: - 22x M4x12x8 Metal spacers (12mm length, 7mm width face to face). - 22x M4x10 Countersunk screws. Specific links have been removed due to inconsistent references. The total cost for these parts is approximately $16 (100 pieces of each), which should be enough to make four VATs. Double-check the standoffs you receive and modify the STL accordingly if the stock hole (measuring exactly 7.2mm face to face) is incorrect. ----- This isn't a direct remix, but rather a response to Mr. Z's use of complex language and perceived ownership of the FlexVAT or VAT design. To please him, I'll pretend it's his work. The original model posted here is licensed under CC BY-NC 3.0, which grants me the freedom to: Share — copy and redistribute the material in any medium or format. Adapt — remix, transform, and build upon the material. As long as I follow the license terms, "the licensor cannot revoke these freedoms." Attribution — You must give proper credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in a way that suggests the licensor endorses you or your use. NonCommercial — You may not use the material for commercial purposes. According to https://creativecommons.org/licenses/by-nc/3.0/, the model was created by "ZioFester" on Thingiverse and has been adapted and redistributed here without any warranty. The model is released free of charge for everyone.