DungeonSticks: Caverns - Spider Archway

thingiverse

[](https://go.ec3d.design/the-ignis-quadrant-ks) DungeonSticks: Caverns - a fast and easy modular cavern design system for gridded battle maps! This project is supported by my Kickstarter, The Skyless Realms. Check out the single entrance piece, a spider-themed archway with gemstone eyes and runic carving. It seamlessly fits with most cavern sets after painting the stone sides to match. This archway particularly works well with the "Dry Cavern" sets. Visit the full DungeonSticks: Cavern collection HERE - I'll be releasing more themed sets as The Skyless Realms Kickstarter continues! What is a DungeonStick: Cavern? <iframe width="560" height="315" src="https://www.youtube.com/embed/1rjOFw4_2XE" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> Tile sets are limited for organic caverns. I created DungeonSticks - a "2.5d" terrain system of walls and entrances to build out your caverns on top of a battle map/mat, table, etc. The focus is quick/easy setup, portability, player visibility, and easy printing/painting. The connection system is a simple drop-in rotating joint requiring no additional clips or fastening mechanism. The walls move to fit organic shapes. The goals are: - Faster and easier than complete tile sets - Reusable, flexible, and combinable with minimal teardown / setup - Easy storage, transportation, and stacking when not in use - Create a 3rd dimension effect without full floors/walls - Offer nearly-zero visual impairment or sight blocking for players on the table DungeonSticks: Caverns contain base construction items to build themed organic caverns of all types. They work with 1" grid systems with limited loss of playable floor space in the interior. A typical "stick" prints in about 1 hour and an entrance in about 1.5 hours. They require no support and minimal infill, filling your print bed up overnight to print a full set in as little as a few days. Printing Notes: All pieces are designed best @ .16mm layer height but up to .3mm should work OK. Little infill (10% or so) is required, but I like 20-30% for weight. No supports are needed for any of the pieces. NOTE - you can mirror every piece in your slicer to get more variations