Dungeon! Game Token and Card Holder Set

prusaprinters

This is a complete set of organizers for all cards and components of Dungeon! the board game to keep your table tidy and allow you to focus on the game. Each tray has an optional lid that you can use to store everything in the respective trays and carry in the game box without worry of them falling out or becoming disorganized.The box is so large that I couldn't think of a reasonable solution to keep the trays from moving around but they should be robust enough to handle some jostling without much issue. You can also set each tray inside the lid but it makes the cards more difficult to grab from the card tray (last picture). If you have any ideas for improvement or optimization I am always open to feedback.Encounter Card Holder & Encounter Card LidYou'll need two of these trays, and optionally lids, to hold the encounter and treasure cards for the six dungeon levels. Each level is intended to take up a single column with the top two “dragon” spots for the monster draw and discard piles and the bottom “chest” spot holding the level's treasure cards.Print DetailsLayer Height.20 mmInfillNoneFirst Layer NoteI slowed my first layer down, for the tray only, to 60% for so the design in dragon and chests stayed adhered using a smooth PEI steel plate.FilamentOverture Black PLA Spell Card HolderHolds the cards for the wizard's spellbook.Print DetailsLayer Height.20 mmInfillNoneFirst Layer NoteI slowed my first layer down to 60% for so the design in the tray stayed adhered using a smooth PEI steel plate.FilamenteSUN Pro Green (Pantone 323C) PLAFigure and Dice HolderThe small area is for the two dice and the larger area fits the eight hero standees.Print DetailsLayer Height.20 mmInfillNoneFirst Layer NoteI slowed my first layer down to 60% for so the grid in the lid stayed adhered using a smooth PEI steel plate.FilamentCreality Matte Blue PLAToken HolderIndividual compartments hold each of the 12 Number tokens, Lose a Turn tokens, Magic Sword tokens, and Defeated tokens. The 12 Number tokens sit in a row on the top. The Lose a Turn tokens fit in the two compartments on the middle-left. The Magic Sword tokens take the middle-right. Finally, the large bottom compartment holds the Defeated tombstone tokens.The lid fits on the tray two different ways but you'll want the divider bar along the top separating the Defeated tombstone tokens into the larger compartment. The other tokens should stay put either way so it shouldn't be too big of a problem if it's not put on as intended.Print DetailsLayer Height.20 mmInfill5% GyroidColor ChangeThe text and symbols on the trays are raised to allow for a color change of the top three layers. You can also paint the raised symbols instead.FilamentBase: Hatchbox Light Purple PLAText/Symbols: Overture White PLA Artwork AttributionThe artwork used in the design is credited to the creators listed below from the Noun Project.dragon by Icons Producertreasure by Adrien Coquetchevron by Nikita Kozinperson by MelloFire by Alina Oleynikexplosion by Abdul WahhabLightning Bolt by richard pasquaTombstone by David Khaimagic sword by lastsparkhourglass by Vectors Market