Duet Wifi Case & Lid

thingiverse

A custom case designed for the Duet Wifi controller board. There are no mounting surfaces on the outside of the case, allowing you to easily add your own mount surfaces as well as any holes you may want to use for your specific application. The case was designed around this model as a reference point. There should be plenty of room inside for all types of wiring configurations. I included three 1/2 inch holes in the bottom of the case where wiring in loom or spiral wrap can be inserted, as well as tie-down support inside where wire bundles may be zip-tied into place. This design was set up for use with a simple 30mmx30mmx10mm fan mounted on the inside blowing across the stepper drivers. Screw holes in the top of the case are sized to allow pressing in of threaded brass sleeves, but you may want to downsize the holes if you will not be using threaded sleeves to receive M3 screws. You can find these threaded brass sleeves on Amazon here: https://www.amazon.com/gp/product/B01IYWUUH8 Update 4/18/2018: I added an adapter plate that allows mounting an Einsy Rambo Controller board on the inside, but unfortunately the USB Port will not be easily accessible from the outside in the traditional manner. Update 5/01/2018: I also added an adapter plate that allows mounting the Controller board for the CR10/s "Creality V2" board. You can view the entire mod on YouTube here: https://www.youtube.com/embed/EwW4efjtXiU