Duet wifi bracket for robo3d R1+

thingiverse

This bracket will securely hold a Duet WiFi board in place within the Robo3D R1+ 3D printer. To achieve this, insert a PCI slot fan and utilize a Dremel to shave down the protruding section that sticks out. Securely attach the bracket to its original location where the RAMPS board was previously situated using two screws. A small amount of epoxy should be applied to the area on the board where there isn't a screw, specifically on the nub, after attaching the Duet WiFi board in the remaining three holes. Next, drill holes in the bottom plate underneath the PCI slot fan. Remove the old RAMPS fan as well. The Duet WiFi board relies solely on passive cooling since it lacks heatsinks; instead, the entire board functions as a heat sink. Therefore, this bracket effectively acts like a duct, blowing air beneath the board to facilitate cooling.