Duet & Duet Wifi Case w/ Cooling

thingiverse

WARNING - Work in process. This is a second revision after the first print test has been conducted. Designed specifically for Duet Wifi (https://www.duet3d.com) and earlier models that all share the same hole mounting pattern, this case has been carefully thought out by an engineer with extensive experience in fixture design. Please provide suggestions and I will make further revisions to update! Features: Wire duct style wire management Dual 40mm fan cooling of board underside (per Duet recommendation) Passive cooling vents on top of the board Ability to add a cover - clear acrylic or printed All holes will self-tap with M3 machine screws. No need for nuts or taps! Additional components required: Top cover mount (for plexiglass) - M3x12MM screws & washers - Qty 4 Acrylic sheet - if choosing clear cover instead of printed (fab drawing included) Circuit board mount - M3x12MM screws - Qty 2-4 Fan mount - M3 screws (length depends on your fan size) Qty 4-8 40MM Computer Fans - Qty 2 Changes 12/20/2016 Added cable tie mount point for wire tie down and to provide strain relief for connections on the board. Added channel to fit the USB plug onto the board while the board is mounted. Changes 12/18/2016 Removed two wire guides at hotend terminals for wire clearance Fixed floor thickness error - now 0.125" thick Added cooling slots on top compartment – also saves material Drastic board pocket dimensioning corrections. Accounts for normal board dimensional variation (pocket is already print tested) Added model and drawing for cover All screw hardware change to M3. Great for commonality and reduces board damage risk Moved 2.25” wiring opening on fan side to better facilitate the pre-wifi board versions. Print Settings Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: No Supports: No Resolution: .2 Infill: 20 Notes: Designed to not require supports! Everything else is a suggestion only.