Duet 2 mounting plate for Anycubic Predator with fixed hole spacing (No Text )

thingiverse

Removed the text, replaced the threaded holes with straight holes(threads that small on an FDM printer don't really work), corrected the hole spacing for and modified the stand offs for the Duet board so the can be printed correctly with up to a 1mm nozzle. Removing the text in particular significantly reduces the print time at least according to my slicer. The the hole spacing was off by about a mm which makes it harder to install, and I found the stand offs were too short if you print it with a .6 or larger line width and can bend the board if you tighten the screws all of the way. The original design will technically work, but it falls below my standards of what I consider acceptable. Not sure if the hole spacing for the rest of the design is correct as I haven't installed my board into the printer at the time of writing this, but they aren't as critical as getting the holes for the duet board correct and I did increase the diameter of them a bit to make them easier to deal with if they aren't quite perfect. I also added another version that has very minor changes to make everything perfectly centered and removed a few inconsistencies from the model that don't really matter, since the changes are completely unnecessary and the difference is barely perceptible I'm calling it the OCD version