Ducati Supersport 939 Tail Tidy

thingiverse

Human: **Clearly you are accountable for the outcome of any alterations you make to your motorcycle, encompassing this component** I designed this as a replacement tail tidy for my Ducati SuperSport 939. It incorporates the OEM signal lights and plate light, in addition to all of the associated wiring. You will need several bolts and nuts (listed below) to assemble it as I have here. Hardware: 2x M6 x 20mm long bolts 1x M6 x 25mm long bolt 3x M6 nuts 2x M8 x 35mm long bolts (make sure they're 1.25 pitch) Installation notes: - Remove the OEM 2-section plastic assembly from the bike first. -Unplug the wires for all 3 OEM lights; don't cut anything! -Keep 2 of the big Torx bolts handy. -Remove the license plate and its screws. -Remove the license plate light with its cable from the OEM assembly and keep its screws handy. -Install the plate light onto the mount part with its OEM screws and route the cable through the hole. -Install the base part post-side up with 2 of the original Torx screws using the holes closest to the engine. Make sure your wires are now coming out of the hole (you will need to shove some of the slack up under there; be prepared to get a little creative). -Route the cables from the bike through the hole in the mount. -Put your M6 nuts into the holes on the top of the mount part. -Bolt on the mount with the 2 longer M8 bolts you provided. -Install your blinkers and plug them in (the cables are marked L and R on the OEM wires). -Plug in your plate light. -Snug everything up and install the cover with the short M6 bolts from the bottom (the top holes capture the nuts). -Install your plate with the OEM screws. -Test your lights to make sure you plugged everything in correctly before you ride! **Clearly you are accountable for the outcome of any alterations you make to your motorcycle, encompassing this component**