Dubro Extended Plate and Hub Adapters

cults3d

I wanted to balance my 6S Arrma Kraton stock wheels. I had a Dubro prop balancer. I created a plate that allowed the width of the RC wheels to accommodate them using my Dubro balancer. I do not know at the moment the thread pitch of the rods Dubro uses so I matched them up with screws I had laying around, so that part at the moment is on you. (after the print I had to pre-drill a bit larger to allow the screws to thread in and let them sit for about 2 hours to forma thread in the PLA) The Plate has holes to accommodate the Dubro arms that hold the disks for balancing which are 50mm apart (side to side) (I will later determine the correct pitch and re-post this) The adapters for the wheels (Arrma Kraton 6S Stock) use a 3mm set screw which will screw into the pre-printed holes without much of a problem. You will however need to facilitate the 5mm shaft. I used a carbon fiber one meant for RC use (hollow) The hex is 17MM to fit the Kraton. The round area on the other adapter is 12mm and fit the Kraton rims fine without any wiggle