Dual towelhanger

thingiverse

This is a nice slick "dual wield" towelhanger. The printed model looks a bit rough but it was done on fastest draft profile with 0.24 layerheight. Should look a lot better on your end! One part is made to screw against the wall and then you can slide the towelholder in place. Because : Who wants to see screw heads? Nobody. Talking about screws: size matters. Use small screws, and check the screw head in the hole BEFORE montage if it does not stick out which will prevent sliding the towelhanger in place and possibly infuriate you. Once attached it fits very snug. But not too crazy snug if you know what i mean. No sanding needed. Recommended settings: - Support: Yes (but it is very very little!) - layer height: 0.10 for slick results - infill 10%-20% - Raft: not needed, strongly adviced not to use raft Enjoy