Dual Sided SD Card Case

prusaprinters

SD card case remix where I duplicated the model and flipped it over so now it has twice the amount of storage in a similar volume. I also made the holes larger to fit my 12x3 magnets.  Print:SD Card Case Bottom.step- x1SD Card Case Top.step- x216 12x3mm Magnets required READ THIS BEFORE ASSEMBLYAssembly: Use a Sharpie and label 8 magnets south and 8 north. It doesn't matter which side is which pole as long as they are opposites. On the base piece, put a small amount of super glue in each of the 4 holes on top. Now put 4 magnets that are all labeled the same in the hole with the labeled side down so that the Sharpie will no longer be visible. if you put the right amount of glue then there should be no overflow but if there is, wipe it with a paper towel. Now let it dry and repeat on the other side with the ones labeled opposite. The magnets should now be attracting through the plastic to hold it in better. now repeat with the tops. put 4 north in one and 4 south in the other, all with the labeled side facing down. After everything has dried sufficiently, you are now free to use as you would like.