Dual linear track X-axis for the Sidewinder X1 from Artillery

thingiverse

What else do you need! 2x Linear Tracks https://www.amazon.de/gp/product/B07LD9V7V7/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 1x M3x3 screw to complete the sled 1x M3x20 screw (for the limit switch of the X axis) 7x M3x7 screw + 1 x M3x5 (for attaching the sled to the linear blocks) 30x M3x8 screw + 30 hook nuts (for attaching the linear track to the original X axis) 3x M4x20 screw + 3x M4 nut + 4x M4 washer + 1x M4 washer large outside diameter (9mm min) 2x small cable ties Manual: - Shorten the two tracks to 365mm - Pull the ribbon cable out of the extruder - Release the belt drive - Loosen the 3 screws that hold the wheels. - Take off the extruder. - Put the M3x8 screws in the tracks and put on the locknuts. - Set the tracks in the profiles and screw them on, not tight. - Insert an M4 nut in the sled. - Put the sled on and fix it with the 7x M3x7 + 1 x M3x5 screws. - Attach the extruder and attach it at the bottom with an M4x20 screw and the large washer - Take a 90 ° angle and align the extruder. - Tighten the extruder with the 2x M4x20 + nuts + washers - Screw the tracks gradually - Attach the belt drive - Plug the ribbon cable back in - Release the limit switch X and put the increase underneath, to fix the M3x20 screw. Caution ! The travel path is reduced to 268mm. Unless you put the Z axis 3mm further away with other screws and sleeves for the Z axis wheels