Dual HDD Raspberry Pi NAS with fan control

cults3d

This project was first inspired by araimbox's PiNAS. I wanted to get rid of the soldering part to connect the hard disks. Also, I was a bit afraid of the temperature management in such a small enclosure, with all the CPU electronics so close to each other. So here it is: Works with a Raspberry Pi 4 and two USB SATA Hard disk drives connected with the shortest SATA USB cables I could find. Small footprint, a 15.2cm x 15.2cm square. Mainly unibody, only two main parts including anchors to ease cable management with small zip ties. No supports needed for any of it. No glue, only M3 screws. Plenty of air vents to prevent choking, plus a Noctua fan that only runs when necessary thanks to Tyler's tutorial on Howchoo.com. A bit of soldering is necessary if you want to achieve this, but it's worth the effort. I use OpenMediaVault on the software side; SMB sharing, DLNA streaming, lots of plugins and you can even run a Plex server. it's a very nice platform. Parts list: PLA, any brand I guess, but I used Prusament one Raspberry Pi 4 two SATA Hard Disk Drives (you may use only one though) two very short SATA USB cables with thin connectors, I used a Sabrent model (see below) one 4mm NF-A4x10 5V Noctua fan one NPN transistor and a resistor if you want to trigger the fan's activity depending on the CPU's temperature (follow the tutorial, link is below) one Ethernet cable a few small 2.5mm zip ties four M3*4 screws two M3*6 screws five M3*8 screws eight M3*5 screws four M3*12 screws four 4mm diameter anti-slip rubber pads The whole assembly process is illustrated below. Some references: araymbox's Pi NAS (https://www.thingiverse.com/thing:3878669) Tyler's fan control tutorial on Howchoo.com OpenMediaVault Sabrent USB 3.0 to SATA cable 4mm NF-A4x10 5V Noctua fan M3 screws