Dual Fang Duct Tevo Tarantula and SN04 Prox Sensor Mount V2

cults3d

This is version 2. I found out after making V1 that the prox sensor set a little too far forward to be effective, so I moved the prox mount back closer to the main bar. I also added a little support for the vertical. After getting my Tevo Tarantula and hearing everyone rave about the Dual Fang cooling duct, I decided I needed one. But at the same time, I was needing to move my SN04 prox sensor out of that horrendous spot on the back of the extruder so I could adjust it. I found 2 items I needed, but according to the Pauli exclusion, 2 objects cannot occupy the same space at the same time. So, working with Bryceletarmo, I was able to get the original CAD file for the fan duct. I then used migeorge's design and redrew it in AutoCAD to fit what I needed. Merged the 2 items together, and here we go. If it wasn't for Bryceletarmo and migeorge's work ahead of me, I am not sure I would have been able to pull this off. Thank you to the both of them. The fan is a 40x40mm fan, as described by Bryceletarmo. The SN04 mount uses the same bolts and washers provided (at least they worked on mine). I suggest adding a washer on the back side of the printed mount, just to make sure the bolt head or nut doesn't pull through. Fan bolts use the same size as the electronics housing fan (in fact, same size fan). Just thread the bolts through the plastic. Usual warning, don't over tighten or you may strip the plastic out.