Dual Fang Duct Tevo Tarantula and SN04 Prox Sensor Mount V2

thingiverse

This is version 2. I discovered after making V1 that the prox sensor was set a little too far forward to be effective, so I moved the prox mount back closer to the main bar for better positioning. I also added some extra support for the vertical structure. After getting my Tevo Tarantula and hearing everyone rave about the Dual Fang cooling duct, I decided I needed one right away. But at the same time, I was needing to move my SN04 prox sensor out of that terrible spot on the back of the extruder so I could adjust it easily. I found 2 items I needed, but according to basic physics, two objects cannot occupy the same space at the same time. So, working with Bryceletarmo, I managed to get the original CAD file for the fan duct from him. Then, using migeorge's design as a starting point, I redrew it in AutoCAD to fit my specific needs. I merged the 2 items together, and here is the result. If it wasn't for Bryceletarmo and migeorge's work ahead of me, I'm not sure I would have been able to pull this off on my own. I want to thank them both sincerely. The fan is a standard 40x40mm fan, as described by Bryceletarmo. The SN04 mount uses the same bolts and washers that came with it (at least they worked for me). I recommend adding an extra washer on the back side of the printed mount just to make sure the bolt head or nut doesn't pull through. Fan bolts use the same size as the electronics housing fan, in fact they're the same fan. Just thread the bolts through the plastic carefully. Remember, don't over tighten or you may strip the plastic out completely.