Dual fan and BLTouch mount for Peter Stoneham's dual E3d extruder mount

thingiverse

This mount adds two part fans and an adjustable mount for a BLTouch bed sensor to Peter Stoneham's outstanding E3d dual extruder setup for Rigidbots. Post-Printing Cleanup and preassembly is crucial here - tap the BLTouch adjuster hole for 3mm and press nuts into fan arms. I found it easier to fully assemble the mount before installing it onto the X carriage (Your results may vary). Hardware you will need: 9 m3 nuts 10 m3 washers 1 m3 x 12 hex head for right mount arm 2 m3 x 8 hex heads for BLT mount 4 m3 x 20 hex heads for fans 1 m3 x 25 hex head for BLT adjuster 1 Ball Point pen spring for BLT adjuster 2 m3 x 15 hex heads for left arm mount If you use Peter's SS bearing mounts like me, you will need two additional nuts and washers. Thread the screws for the left arm up from the bottom and use the added hardware to lock the bearings into place before installing the fan mount. This allows you to remove the fan mount without disturbing the bearing adjustment. How I Designed This It was based on the DXF files I got from Peter for his dual extruder mount using Fusion 360, going through six iterations before I was happy with it.