Dual E3D V6, Independently Height Adjustable Mount for Rostock Max V2 - Locknut Mod

thingiverse

Modified E3D Dual Mount for RoStock MAX V2; adds clearance for all three M3 SHCS mounting and adjusting 2nd extruder. "Mount 2" reworked for clearance around M3 nylocks. Thinking about incorporating M3 or 6-32 helicoils directly into the part for V3 version. V2 parts netfabbed. Instructions: Printed in solid ABS, assembly needs attention: Place Mount 1 above platform; locate Extruder 1 below with extruder seated on groove of Mount 1. Mount 1 with Extruder 1 located but not attached on top. Mount 2_V2 assembled with Locknuts in place; load and position Extruder 2 into its mounting groove, secured to top of Locknuts. Mount 2 with top face now flush on underside platform level. Move this surface upward carefully toward bottom platform and extruder surfaces parallel as possible Align lock nuts loaded onto top face Mounts to thread through hardware mounted from the underside into the Locknuts secure and level. As soon as all contact points between platform top surfaces and extruder parts is even, continue sequentially threading screws tightening all mounts at an appropriate force until all surfaces meet smoothly and flat then lower this portion slightly further align. Install additional 6-32 hardware below running it from underneath down the back of your printing system to secure everything onto the base platform. Once more stable turn Extruder 2's position level to mirror its dual twin above while simultaneously carrying on with your print.