DTM Vase Mode

prusaprinters

This is a quick vase mode version of: https://www.prusaprinters.org/prints/27748-dtm-v30-a4-face-shield-ppe-for-covid-19-remix-of-p/files It prints quicker (30min) and with less filament used (24g) Version 2.1 - closes the top Version 3.0 - improves pins adds indent for support and breath-ability. Version 3.1 - improved side hooks and added curve to the end for comfort +added 4 pin EU version +added 6 pin US 3 hole punch version Print instructionsI printed it in vase mode with .3mm layer height. I left the first layer speed the same but doubled everything else. Extrusion width was increased to 0.6mm (needs testing). I had to go to my filament setting under cooling and change the "Cooling Thresholds, Slow down if layer print time is bellow: " to 5 sec.