DT02 Front Suspension Damper Bridge

thingiverse

I just broke my front damper bridge of my Tamiya Super Figther G (DT02 chassis) and I thought well why not replace it with a 3d printed part. Well I have to admit that even if I bought the original spare part it also wouldn't last the next crash @~70 Km/h so I will from now on 3d print this sacrificial part x-D I tried to design this as precise as i could and it fits quiet nice. Only the arms are a bit off but that wont do much harm I guess. Printed this with the rear facing part at the bottom on a raft with a good amount of support. This might sound counter intuitive but this makes sure that the layer lines are in the right orientation for maximum strength. The pictures show my first print with some minor issues that I corrected before uploading. The first one who spots the differences gets a cookie in the comments ;)