DSLR Cokin Filter System Hood - Series P

thingiverse

I'm replacing the broken Modular Hood for my Cokin Series P filter system by designing a new one. A photo shows the original (broken) hood and its printed replacement. The replacement clamps onto the support just like the original did, with slight pressure applied to the two flat sides of the hood, which causes the other two sides to widen and allow them to slide over the support until the pins from the support go into the slots in the hood. This design doesn't replicate the original's ability to stack multiple hood pieces together to create a longer hood since I didn't need that feature. If I get some spare time, I might work on a second version that includes stacking. Instructions: Try printing with PLA and using 0.2mm layer thickness along with enabled support to obtain nice and precise slots.