DS0138 Case with KAISH 9V Battery case

thingiverse

idskot's design was used to create this case. This is a work in progress. Still working on buttons and switches because the original had very flimsy and wobbly parts that needed more structural support to eliminate switch wiggles as much as possible. INSTRUCTIONS: Support is required for the battery compartment. That area will be covered by the battery case, so it doesn't matter if it looks bad down there. Make sure all buttons and slide switches fit through their holes. Attach slide switch pieces to the switches first, then insert all buttons into their holes (the Reset button needs to be oriented properly). Ensure printed buttons activate everything correctly before assembly. If all elements are soldered centered, alignment should not be a problem.