DrZzs Pixel Pro v4 Case

thingiverse

Snap-in case for the Pixel Pro V4.1. My plan is to conceal this as much as possible, hence only putting a bump at the wire terminals as needed. I measured a max of 27C on the outside of the case after running lights in an animated pattern for 24 hrs. Printing: Bottom - print as is, no supports Top - Print on the front face (where the bump-out is flush with the side) on the plate. Doing this I can get by without using any supports. There's a tiny bit of droop on the inner wall, but it does not affect anything and far outweighs having to deal with supports. I didn't bother to change any settings specifically for better bridging. Full print with 5% gyroid infill and no supports is 11g/3.69m according to Cura.