drying holder for AirFit P10 parts after washing

prusaprinters

<p>It is recommended to print this from the side, which will produce the best results and does not require any support structure by the design of the structure.</p><p>This holder can be easily attached to the aluminum wall of a shower cabin as long as it is no thicker than 3mm. For thicker walls or other attachments methods, like screw mounting the model should be modified accordingly.</p><p>I printed with 0,2 mm height with PETG and 20% infill. The precise setup should not be particularly relevant due to the structure of the model, though I would not recommend PLA due to the fact this is meant to hold wet material. Infill is needed only in a few corners, such that the amount of infill is likely not a relevant factor.</p><p>In the second version I also added a holder for the textile headband.</p><p>If you want a clip to attach those tubes to furniture you may want to check out <a href="https://www.printables.com/model/246904">https://www.printables.com/model/246904</a> as well.</p>