Drybox (wall mountable)

prusaprinters

<h3>This a is a work in progress</h3> <h3>To Do:</h3> <p>• Push-to-connect fitting threads are difficult to align and thread when printed at an angle. May depend on your printer.</p> <h3>Changelog:</h3> <p><em>2019-08-30</em>: Fixed 5/16" threads on printed nuts<br/> <em>2019-09-01</em>: Recessed part of latch to improve bridging</p> <h3>Remixed from:</h3> <p><a href="https://www.thingiverse.com/thing:2900930">Parametric Enclosed Stackable Spool Holder</a> by <a href="https://www.thingiverse.com/Desert_Hobo">Desert_Hobo</a></p> <h3>Changes from source:</h3> <p>• Moved filament exit to underneath box, in front<br/> • Expanded box to give filament a straighter path<br/> • Built in threads for push-to-connect bowden fitting, removed lid cutout<br/> • Made bearings/rollers simpler, easier to print<br/> • Added cutout for humidity sensor and a TPU seal<br/> • Added pocket for a filament color sample<br/> • Thickened hinges<br/> • Reduced clearance so that it can fit on a 200x250 printbed<br/> • Bulked up the print-in-place latch, require fewer supports</p> <h3>Parts</h3> <p>• 1x PC4-m10 push-to-connect fitting. Actual threads are 1/8" BSP<br/> • 1x 5/16 x 107mm threaded rod, nuts for hinge (<em>optional</em> or printed nuts)<br/> • 4x 608 bearings<br/> • 2x 7.8 or 8mm x 88mm smooth rod for rollers (<em>optional</em> or use printed roller)<br/> • 6x m3-8 screws <em>or</em> 6x m3-12 screws + 6x m3 nuts for latch<br/> • 4x m3-12 screws for latch<br/> • Humidity sensor, 44.5x25.5mm</p> <h3>Filament</h3> <p>• 432g for the box<br/> • 20g for the latch<br/> • 10g for the wall mount<br/> • 24g for two rollers (if not using smooth rod)<br/> • 11g NinjaFlex for the seals</p> <p>See <a href="https://www.thingiverse.com/thing:2900930">parent project</a> for lighter-weight latch, and non-print-in-place latch which uses screws instead.</p> <h3>Print instructions</h3><p>Should print fine without (generated) supports.</p> <h3>After Printing</h3> <p>Break off and remove modeled supports from humidity sensor cutout and filament sample pocket.</p> <p>Print latch on its side. Remove modeled supports from inside of latch hook.</p> <p>Maybe seal the inside (untested)</p>