Drybox Outlet for PTFE Tube (Festo fitting QSM-M5)

prusaprinters

<p>To prevent the filament from absorbing moisture and degrading, such as ABS, ASA or water-soluble filaments, it should always be kept dry</p> <p>To ensure that the filament remains dry during printing, it is recommended to print directly from the Drybox.</p> <p>For this purpose I have an adaptive outlet which can be closed again after printing by inserting a lid.</p> <p>The design is made for the Festo QSM-M5 fittings. These can be easily tightened with an open-end wrench. Due to the countersink it seals well.</p> <p>For the attachment to the drybox I recommend to use more glue instead of screws, because the glue also acts as a seal.</p> <p>Do not glue your fingers when sticking the glue ;D and roughen the glue surface to increase the adhesion.</p> <p>You are welcome to remix and split the model. I am interested in your opinion, because only through feedback you can become better :P</p> <p>Happy Printing :D</p> <h3>Print instructions</h3><p>For the outlet system you need a Festo QSM-M5 fitting, fitting adapte, lid and a holder.</p> <p>The layer height for an optimal result is 0,15mm.</p> <p>PRUSAMENT PETG JetBlack was printed with a nozzle temperature of 240/250°C and a bed temperature of 85/90°C.</p> <p>Extrusionfactor 0.95 (variable)<br/> 100% Infill</p>