Dry Box Spool Holder Mount Guide for 21 Cup Drybox

prusaprinters

<p>The <a href="https://www.prusaprinters.org/prints/68223-dry-box-spool-holder">Dry Box Spool Holder</a> by bradm10000 is a very nice solution and much better than the rollers that I was using before. &nbsp;Especially as more and more manufacturers are using carboard spools that don't always roll perfectly. &nbsp;Full credit to bradm10000</p><p>The challenge with this system is placing the mounts on the sides of the container evenly and identically.</p><p>This tool will help consistently place the mounts at the correct location on both sides of the storage container.&nbsp;</p><p>Find the center of the dry box, use tool as a straight edge to mark the rim of the container with a marker on both sides.&nbsp;</p><p>I used Scotch brand double-sided poster tape to make the end of the tool sticky. &nbsp;You could also add a layer of masking tape to the edges to provide a friction fit with the sides of the mount.&nbsp;</p><p>Use your glue of choice on the back of the mounts. I am using 3M VHB (<a href="https://www.amazon.com/gp/product/B06Y31C3B9/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&amp;psc=1">link</a>). It seems to hold well. Insert the mounts into the tool as shown.</p><p>Align the notch of the tool with the mark that you made on the rim of the container. &nbsp;Press the mount to the side. Hold the mount against the container as you remove the tool. &nbsp;</p><p>Repeat on the other side. &nbsp;</p><p>&nbsp;</p><p>This printed in about 40 minutes on 0.20mm Speed with 15% infill using eSun PLA.&nbsp;</p>