Dry Box Parts

thingiverse

I designed these parts to create my very own filament dry box. I used M3 15mm nuts and bolts for the nozzles pieces, originally I wanted to use M2 but could not get them at my local hardware. Bolt holes will need to be drilled out to suit M3 haven't tried M2. Filament nozzles will need to be drilled out to add PTFE tubing for less restricted extruding. I used M4 15mm nuts and bolts for the rod holders, I was going to use M3 but I decided on M4 due to more strength. These holes will also need to be drilled out to suit M4. Rod holders have an angled base to allow for the slope on the side of a storage container. I used M3 15mm nuts and bolts on the dehumidifier holder and placed the holder as low as possible to allow more room for filament rolls. You will notice a hole on the bottom of the filament holder, this was put there to recharge the dehumidifier inside the box BUT this cannot be done obviously without creating a ton of moisture inside the box, so DO NOT Recharge The dehumidifier while its inside the dry box. Each spacer has a hole to allow locking screws. Spacers where added to stop filament rolls rubbing together and causing restricted filament extrusion.